re-porting of Hardware Abstraction Layer library

$750-1500 USD

Cancelled

Posted

about 10 years ago

$750-1500 USD

Paid on delivery

We are looking somebody who make re-porting of Hardware Abstraction Layer library file from ATMEL SAM3X8E to NXP LPC1768. Both microconrollers are ARM CORTEX-M3, but there are some differences in the peripherial resources and pin mapping. Contractor must have own board with LCP1768 and USB interface. Contractor should provide: - re-ported source and binary code compiled under GCC Full final payment only, after verification of code. Regards, Robert

Electronics

Embedded Software

Microcontroller

Software Architecture

Project ID: 5829889

About the project

6 proposals

Remote project

Active 10 yrs ago

Looking to make some money?

Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

Get paid for your work

Outline your proposal

It's free to sign up and bid on jobs

6 freelancers are bidding on average $1,222 USD for this job

@baobui

Hi, I have worked with LCP and have the LPC1768 board. I can do it for you in short time. If you are interested, please discuss further

$1,500 USD in 20 days

4.9

(13 reviews)

5.7

@LearningNew

ping me, and we will give you the solution............................................................................................

$1,315 USD in 25 days

5.0

(10 reviews)

5.1

@shallufreelancer

..................................................................................................................................................

$1,444 USD in 20 days

0.0

(0 reviews)

0.0

@divinesoft1

Hello Sir, We have gone through the details you have provided and we have already worked on a similar project before and can deliver as u have mentioned and would be pleased to work on this with you to deliver the results that you have expected and we have already worked on a similar project before and can deliver as u have mentioned We are sure you will not be disappointed if you give us this opportunity. Our team is experienced, creative & efficient enough to get your job done well. We have an impeccable record and all our clients enjoy working with us, we are sure that you will too, our prices are cheapest in market. can u provide your email or sky-pe etc for further discussion about the project I am ready to discuss with you with best Regards

$1,250 USD in 20 days

0.0

(0 reviews)

0.0

@kosuriv

A proposal has not yet been provided

$1,250 USD in 20 days

0.0

(0 reviews)

0.0

@TruongVu90

I see you want to porting a HAL in ATMEL SAM3X8E. Currently I have development board using LPC1768. With my experience in NXP chip with alot project work with NXP chip. I think I'm a master with LPC serial MCU of NXP . I think I'm a good candidate for the project.

$777 USD in 20 days

0.0

(0 reviews)

0.0

@jiteshverma

We have experince of developing low-level HAL firmware code for microcontrollers with C for TI and Intel microcontrollers. Let's discuss it further. Thanks, Jitesh

$850 USD in 12 days

0.0

(0 reviews)

0.0

@khmtambi

Hello. I have a board using NXP LPC1768. The name of the board is LandTiger Board which is the closest clone of Keil MCB1700. The board uses all the ports necessary for training purposes. I have been doing programming on this board on keil MDK ARM compiler but I think it shouldnt bee a problem for me to program the controller in GCC. I can make the project in somewhat lesser time than I have asked for (60 days). Typically I will take around 1 month to 45 days. Thank you!

$1,444 USD in 60 days