DIGITAL CIRCUIT------VENDING MACHINE
$10 USD
Paid on delivery
****Designing and building the electronics of a
vending machine with 9 different inputs and 10 different LED outputs. Each input can be implemented with a switch or simple jumper wire and each output must be implemented with an LED. You will design a state machine for this system and
then implement that state machine in software using the MSP430. You must use two 74LS377’s in a shift register configuration to display the output. The requirements for the project are below:
1. Accept and differentiate between money denominations (you will use switches to
indicate what denomination was inserted). Signals must be properly de-bounced in
software to prevent multiple entries. – 4 inputs
2. At least 4 selections should be available with the following price points: $0.50, $0.80,
$1.10, $1.50 – 4 inputs
3. At any time (provided there is money credited to the user) a return change button
should be able to reset the money counter while triggering an led to indicate change has been returned – 1 input and 1 output
4. Track how much money has been credited to the user using an 8 bit LED array (8 bits
can display between 0 and 255, for this project we will assume that the total money
credited is the decimal number divided by 100 ex: 135=$1.35) – 8 outputs
5. An indicator that not enough money is credited for a pushed selection – 1 output
6. System must keep track of inventory in the machine. It can be assumed that in the
initial state, the machine is full and there are five items for each of the four selector
buttons.
7. Show that an item is out of stock – 1 output
8. You may only use two pins as outputs from the MSP430 (Hint: think shift register)
9. You will make two versions of the final software. One will perform simple polling of the input signals. The second will use interrupts to monitor the input signals.
10. Input signals must be pull high or low with internal resistors of the MSP430
****DON'T HAVE TO WRITE CODE.
****JUST DEVELOP A STATE TABLE AND STATE DIAGRAM AND DRAW THE CIRCUIT TO BUILD ON BREADBOARD.
Project ID: #12217731
About the project
7 freelancers are bidding on average $45 for this job
Developer of electronic products, experience in development of temperature control equipment, motor control, static power meters. Certified by microchip.
hello, I am an electrical engineer , I studied electronics too, I used to do a lot of digital circuits, u can see some samples on my profile
Hi, Basically I'm an electronics engineer. I'm expert in embedded system design. I am sure I can help you. Please come to chat for more discussion. Thank you
Dear Employer, I would like to apply as a Designer in your job post. It says that you are looking for Graphic Designer and also who is a detail-oriented person. I think that I am the right person for the job. I More
