REFER TO THE ATTACHED FILES
Design of an Elevator Control Mechanism for a Small Airplane
You are asked to design a control mechanism for the elevator of a small single engine airplane, shown to scale in Figure 1. For an airplane to gain or to lose altitude in normal operating conditions, it is necessary that the pilot control the pitch motion of the airplane by changing the angle that the elevator in the tail section makes with respect to the horizontal. For this purpose, the pilot must push or pull a stick placed in front of him/her. The control mechanism that you are asked to design will transmit the motion of the stick to the elevator. When the pilot pullsthe stick, the elevator must move up in order for the airplane to pitch up and to gain altitude. When the stick is pushed, the elevator must move downward in order for the airplane to pitch down and to lose altitude. The range of motion of the pilot's arm should preferably be within 180 degrees from the horizontal x-direction for push to -120 degrees for pull (refer to Figure 2). The motion of the stick must cause the elevator to rotate -20 degrees and +20 degrees from the horizontal direction (refer to Figure 2). Note that there are areas of the airplane that are reserved for passengers, fuel tank, etc. which cannot be used for placement of the mechanism. The available space for placing the control mechanism is shown in Figure 2 as the shaded area. The drawing is to scale so that you can measure all the necessary dimensions. All the motion of the designed mechanism must be within this area. You are not allowed to use belts, chains, cables, nor pulleys.
24 freelancers are bidding on average $274 for this job
i have 10 years experience in aeronáutical sector, i developed 5 ilumination systems and 8 mechanical mechanism to airbus military and ADS. i participe in visión system to a330 mrtt and C295 aircrafts