Just a man with an idea.
Updated: January 18th, 2019
I've updated this project description (again) to clarify a few more things and correct and earlier error.
- Bids exceeding $250 will be immediately deleted.
- This project is not intended to be mass produced, and I intend on making the files freely available. So I need to keep the costs down or it's just not realistic.
I have a very simple and rather small PCB I need designed (roughly 3.5cm x 2.7cm), essentially a bare bones (2) port USB 2.0 HUB (non-powered) with a microSD card reader connected via one of the hubs ports (direct not via USB), and a MicroUSB Type-B Female connection for the other port. The smaller you can make it the better, even if it has to be double sided. Although I would like to be able to hand solder the components as well as keep it to a single side to help reduce the cost of production. The size of the board should also not exceed 1"x2".
No mounting holes are required, neither is an enclosure, like I said, simple!
The USB hub should ideally be designed around the FE1.1S as I have easy access to this component, unless you know of another chip that can allow the operation of a USB device and the SD card simultaneously. The HS8836 and HS8826 are also options. You can see some diagrams for those in the files tab above.
You should have prior PCB design experience and an understanding of electronic circuits and be independent and free thinking. I have provided a BOM of primary components below, but don't expect any schematics or a complete BOM. I have attached a block diagram in the files section, yeah...sorry it's the best I can do. You're also welcome to suggest changes to the BOM.
You can use Altium, EagleCad, or KiCad for the boards design.
That's really about all the information I can provide you, what can I say, my needs are simple, the idea is simple.
(This is only an example of parts. Please feel free to make changes.)
FE1.1S or HS8836 (USB 2.0 HUB)
12MHz Frequency Cylindrical Crystal Oscillator 2x6mm Case (Not Required for HS88*6 Chips)
105162-0101 (MicroSD Card Header/Socket)
HS8826 (USB 2.0 MicroSD Reader) *Corrected January 18th, 2019
67 freelancers are bidding on average $170 for this job
Hello I am electronic engineer and PCB designer and I can do your task I work in Eagle and Altium (prefer) We can discuss any moments and I believe in our good cooperation Regards
Hello. i am electrical engineering expert and i have good skill in this field i will do my best and you will get good result i did many works in freelancer site please let's work with me thank you very much