Add an I2C device on TI Sitara SoC

Closed Posted 5 years ago Paid on delivery
Closed Paid on delivery

Hi,

we need to develop linux driver for our expansion board for the Beagleboard X15. The expansion board contains 2 CMOS Sensor of Onsemi MT9V024 and will work in parallel / stereo mode. The CMOS Sensors can be configured by i2c interface and the data out will go via LVDS to Deserializer to Video Parallel (VIP).

Now we need an expert who can assist our developer to get the kernel modul driver done. At the moment we have enabled and added i2c-4 bus connecting with I2C of the sensor in device tree, and after that the i2c-4 showed up as /dev/i2c-4 node, but the sensor didn't respond when using i2c linux tool i2cdetect.

We need someone with experience in kernel device tree, be able to work with schematic, Linux GPIO and kernel module driver. It would be prefered if the expert has used to work with TI Linux Processor SDK before.

Details we can explain you on PM.

C Programming Electrical Engineering Electronics Linux Microcontroller

Project ID: #17352241

About the project

1 proposal Remote project Active 5 years ago