Closed

DC-DC vehicle power supply

Would like to clone the DC-DC vehicle power supply from Mini Box (see link below)

Must be design on a outline of 1 inch x 6 inches doubled side surface mount using a 4 layers PCB, with no mounting holes, primary side should not have no components higher than .375?? other than the connectors, secondary side components no higher than .124?? prefer no thru components other than connectors.

With the exception of (software, USB connection and ON/OFF switch based on ignition status)

Would need this a very quick turnaround

M4-ATX, 250w output, 6v to 30v wide input Intelligent Automotive DC-DC Car PC Power Supply

[www.mini-box.comM4-ATXsc=8&category=981][1]

M4-ATX is an intelligent, high power, vehicle (DC-DC ATX PC power supply designed for use with car pc or general purpose battery powered applications.

M4-ATX is a wide input (6 to 30V) vehicle / car / battery operated ATX power supply capable of surviving tough car engine cranks (down to 6V) as well as transient over-voltage situations.

____________________________________________________

## Deliverables

## Platform

none

Skills: Anything Goes, Electronics, Engineering, Project Management, Software Architecture, Software Testing, Testing / QA, Usability Testing, Website Testing

See more: vehicle design automotive design, dc design, car higher, vehicle design software, voltage , supply, power, POWER SUPPLY, mount, dc, dc to dc, dc dc, Automotive engineering , Automotive battery, engine mount design, voltage design, pcb design project box, switch engineering, car engine design, design voltage power supply, pcb based project, vehicle management project design, power pcb design, voltage supply, engine car design

About the Employer:
( 0 reviews ) Tampa, United States

Project ID: #2794863

2 freelancers are bidding on average $425 for this job

abhishekkumlxpsi

See private message.

$425 USD in 30 days
(1 Review)
1.3
ztxtech

See private message.

$425 USD in 30 days
(0 Reviews)
0.0