Design and build a prototype Bluetooth device
$1500-3000 AUD
Paid on delivery
I need a tiny electronic module designed with the following details:
- BLE bluetooth 4.2 connectivity
- three axis gyroscope
- three axis accelerometer
- magnetometer
- range extender for bluetooth
- microprocessor
- inductive charge receiver
- bluetooth antenna
- small power source (poly or li-ion battery)
- 4 layer PCB board
The unit needs to be smaller than 12mmx12mm. The features required are:
- record and send the data from the sensors to a paired device in packets
- have a range of at least 100 metres
- be able to transfer data while moving and spinning (transfer/connection issues to the receiving device?)
- be able to withstand high force and impacts (will be encased in silicon, but still needs to be tough).
- firmware to go with the hardware development
- inductive charging to allow the unit to be charged wirelessly (needs to be as small as possible, efficiency isn't an issue).
For more details of the use of the unit please message me to have a discussion.
Project ID: #11335441
About the project
21 freelancers are bidding on average $2730 for this job
Hi, I read your project details. I can implement all features except inductive charging. I would like to discuss the project in more details. Looking Forward, Khawaja
Hello dear I have experience in designing electronics circuits and can make your project. I will make your project practically on breadboard and will provide you circuit, code and PCB design. Also i will design your p More
I have over 35 years experience as an electronic design and PCB engineer, please see my profile for more details I believe I could help with the PCB design and manufacture but not the case or the software. I have rec More
hello after reviewing the project description, the size you require (12mm x 12mm) is very small. even with 4 layer board, we can not place all the components you need in a very small palce. thanks.