Build an Arduino Water Level Controller
$30-250 USD
Paid on delivery
Thanks for looking,
This job is to design a PCB layout and program a simple Arduino water level controller.
Specs
Done in Eagle only
The board should use the ATMEGA328P , Mosfet for switching the pump, and [url removed, login to view] DC jack for power input.
The board should have an ISP header for programming
The program needs software to stop the pump running if something is wrong like the float switch is stuck on for to long (working example program that you can use is attached)
Using parts only from Seeed Studio Open Parts Library (Big eagle library)
[url removed, login to view]
Inputs:
One input from a water float switch (on/off)
2v DC power
Output
12v DC pump (1 amp)
Buzzer for fault conditions (eg float switch is stuck on)
Operation
When the water level is low the pump turns on to put more water into the tank. When the float switch turns back on the pump stops.
I have good electronics and eagle experience so I can help with any questions you may have during the project.
Thanks for your interest,
I look forward to working with you!
Project ID: #7554497
About the project
Awarded to:
Hi, I have many years experience in electronics and microcontroller based product design. Most recently I have been working with Arduino based designs in both the hardware and software stages. Your project seems ha More
4 freelancers are bidding on average $229 for this job
Hello Sir, I am a full time working freelancer and I am available on freelancer most of times and I can provide you the required prototype as you want it. I have very good feedbac More
I can help you .........................................................................................................................................
HI I'm Chamika , and let me Introduce me and my works with Employers , I'm Electronic Engineer from University Of Moratuwa , Currently I'm Developing UAVs for Production with collaborate with two companies. I h More