LabVIEW Jobs

Assalam o alaikum, I am looking for electrical engineers having expertise in following areas:  Embedded C Programming.  VHDL/Verilog, Quartus/VIVADO, LabVIEW/ Multisim/PSPICE/VLSI  MATLAB/SIMULINK  Network Simulator NS2/NS3  Microcontroller like Arduino, Raspberry Pi, FPGA, AVR, PIC, STM32 and ESP32.  IDEs like Keil MDK V5, ATmel studio and MPLab XC8.  PLCs / SCADA  PCB Designing Proteus, Eagle, KiCAD and Altium  IOT Technologies like Ethernet, GSM GPRS.  HTTP Restful APIs connection for IOT Communications. Actually I have multiple projects in different domains of electrical engineering and I already have a team of engineers working on them but due to workload I am looking for few more engineers to be a part of my team and work with us on regular basis.

Project: Finalize real-time joystick controller (PID/MPC tuning, smooth tracking, stability) We have an application that is nearly complete. The remaining work is the joystick control layer: converting tracking error into smooth, stable analog stick commands (RX/RY) in real time. This is NOT a computer vision model training job and NOT a machine learning task. Detection/tracking and state estimation are already implemented. The work is primarily control engineering + signal shaping + real-time tuning. What you’ll do Improve RX/RY command generation for fast acquisition and smooth steady tracking Reduce jitter, stick-slip, overshoot, stalls, and inconsistent corrections under noise/latency Tune and/or redesign: error normalization & scaling response shaping (curves, tanh/l...

I am assembling a pool of recently-graduated electrical engineers from Pakistan who can jump straight into hands-on circuit design, MATLAB/Simulink modelling, and clear, publication-ready report writing. Day-to-day work will range from breadboard-level prototyping to full simulation and verification, so the stronger your foundations in analogue and digital design the better. The tasks you’ll tackle typically start with a concept sketched in Proteus or Multisim, move into schematic and PCB work in Altium, and finish on the bench or in a virtual lab via LabVIEW or TinkerCAD. Microcontroller and embedded targets rotate between Arduino-based boards, Raspberry Pi modules, and mid-range FPGAs, so comfort switching among those platforms is essential. Core expectations • Design or r...

I’m expanding an electric-vehicle program and need an automation engineer who already understands the unique behaviour of traction motors, motor controllers, and steering controllers in an EV environment. Your background should let you move quickly from concept to hardware-in-the-loop without a long learning curve on high-voltage safety, torque commands, regenerative braking logic, and steering-by-wire nuances. Here’s what I’m looking for right now: • Analyse my existing drive and steering control architecture and spot any weaknesses in signal flow, software logic, or fault handling. • Propose and implement automated test sequences so we can validate new firmware drops at the push of a button—ideally using common EV toolchains such as MATLAB/Simulink...